Super small space storage
As a part of my quest to get to the house ready for a new baby, I realized that making some of our closet and storage areas more functional would be a key component. When you live in a small space, you really have to use what you have wisely.
So this past weekend I made some plans and got some supplies to fix a few of these areas in our home. One space on the agenda is our hall coat closet.
Here it is right now. I have big plans for this tiny space, but first I had to do a little something with an even tinier space. You may notice that on the floor of our coat closet sits the parts to a vacuum cleaner. I have a Dyson Digital slim, which I love. It transforms easily from a floor vacuum to a handheld and runs on a battery so I never have to mess with a cord while I’m using it. But it comes with several attachments that just get thrown in the bottom of the coat closet, simply because I don’t really have a better place for them. Until now…
Here’s our hot water heater closet. This is right off the kitchen in the middle of the house. It would be a convenient place to store things if it wasn’t full of a hot water heater. But as it is the door rarely even gets opened. When I was assessing our storage situation I realized that I might be able to make this tiny space useful after all. So I did!
I managed to squeeze in just enough storage to hold my vacuum and all it’s little attachments. I can finally keep my vacuum off the floor! I can finally devote my coat closet to only coats! So exciting!
Here’s how it went down.
First I measured. That was essential. It really is a tiny space so I knew I would have to be careful to get supplies that could actually squeeze in there.
Then I went shopping. I bought 3 plastic bins, some shelf brackets, and some screws with washers and nuts (A big thanks goes out to the helpful Lowe’s worker who helped me pick out the right screws. Who knew there were so many overwhelming options?)
Along with those new supplies I needed a drill, a screwdriver, and a measuring tape.
Then I measured again, this time knowing the size of my bins and brackets. I made marks on the wall of where each screw should go for my brackets so the bins would be spaced nicely apart.
Then I drilled. I made pilot holes for each of the screws to make everything go in a bit easier.
Then I screwed the brackets in place. By far the most difficult part of this project was maneuvering around the hot water heater to get the screws in the right place. If you do a similar project in space where you can actually stand in front of the wall you’re working on, I guarantee it will go much more quickly for you.
Once all the brackets were in place it was time to attach the bins. Since these bins were transparent I could just sit them on top of the brackets and make a mark for where each of the screws should go. Easy!
I then used my drill again to make holes in the bins where the screws would go. Then I fastened the bins to the brackets using the screws, washers, and nuts.
Even though these bins are pretty cheap and slightly flimsy feeling, the brackets provide plenty of support so I feel confident that they will be able to hold anything I need them to. My vacuum cleaner is thoroughly enjoying having a tiny space of it’s very own.